AIRTRONICS M12 Guide de l'utilisateur télécharger pdf (Page 16)



The position of the Steering Wheel can be switched from the Right side to the Left side to accommodate Left-handed drivers. This

makes the M12 much more comfortable for natural Left-handed drivers to use.

To change the driving position for Left-handed use, follow the steps below:

1) Using a 2.5mm hex wrench, remove the three socket cap screws (A) that hold the display

switch cover in place, then carefully pull the display switch cover off.

2) Using a 2.5mm hex wrench, remove the two socket-cap screws

(B) from the bottom the transmitter that hold the main body in

place.

3) Carefully pull the main body up and off the base (C), being careful not to

damage any of the wiring.

4) Rotate the main body 180º (D), then push it back down onto the

base (E), being careful not to pinch any of the wiring.

5) Reinstall the two socket-cap screws you removed previously to secure

the main body to the base.

6) Reinstall the display switch cover. Installation is the reverse of removal.

When reinstalling the display switch cover, make sure to install the

two machine screws into the sides of the cover and the one

self-tapping screw in the top of the cover.

Changing the Direction of the Push-Button Rotary Dial:

When you switch the driving position as described above, the direction the Push-Button Rotary Dial moves the Programming

Cursor will be reversed. If desired, the direction the Push-Button Rotary Dial moves the Programming Cursor can be changed.

To change the direction the Push-Button Rotary Dial moves the Programming Cursor, follow the step below:

1) Press and HOLD the ENTER key, then turn the transmitter ON. Release the ENTER key AFTER the transmitter finishes initializing

and beeps once.

 

Activating the Left Side Switches:

Two duplicate switches (Sw3 and Trm5) are positioned on the left side of the transmitter for use in the left-handed driving

position. In the default configuration, these switches are Inhibited for right-handed use. When you switch the driving position as

described above, you will want to Activate these switches for ease of use.

To Activate the Sw3 and Trm5 switches on the Left side of the transmitter, follow the steps below:

1) Remove the battery cover from the bottom of the transmitter, then remove the battery holder.

2) Flip the switch that's in the base of the transmitter below the battery holder toward the Front of the transmitter. When the

switch is toward the Front of the transmitter, the left-hand switches will be Active and when the switch is toward the back of

the transmitter, the right-hand switches will be Active.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 115 116

Pas de commentaire

AIRTRONICS M12 Guide de l'utilisateur Page 16