AIRTRONICS M12 Guide de l'utilisateur télécharger pdf (Page 14)



3) When satisfied with the adjustment, tighten the Throttle Trigger mounting

screw (A).

As you adjust the Throttle Trigger position, the Throttle Trigger Position

Adjustment Indicator (C) will move, indicating the current position of

the Throttle Trigger.

The total adjustment range is approximately 5mm. Do not attempt to adjust the Throttle Trigger position beyond the limits

indicated by the Throttle Trigger Position Adjustment Indicator or damage may result. Moving the Throttle Trigger position

does not affect the physical movement of the Throttle Trigger.

The position of the Throttle Trigger can be adjusted forward or backward to change the feel of the Throttle Trigger during use.

Some users may prefer the Throttle Trigger positioned farther forward and some users my prefer the Throttle Trigger positioned

farther back. It all depends on your personal preference.

To adjust the Throttle Trigger position, follow the steps below:

1) Use a philips head screwdriver to loosen the Throttle Trigger mounting

screw (A) from the Left side of the transmitter.

2) To move the Throttle Trigger backward, use a philips head screwdriver

to turn the Throttle Trigger Position Adjustment Screw (B) counter-

clockwise. To move the Throttle Trigger forward, turn the Throttle

Trigger Position Adjustment Screw (B) clockwise.

3) Feed the connectors from the Trim Switch assembly

through the hole in the offset plate, then very carefully plug

them into the matching connectors in the transmitter.

4) Being careful not to pinch any connectors or wires, align

and secure the offset plate to the transmitter using one

M3 x 14mm socket-cap screw (B) and two M3 x 8mm

philips head screws (C) included. There are small notches

in both the Trim Switch assembly and the offset plate that

line up with corresponding small tabs in the offset plate

and the transmitter to ensure both the Trim Switch assembly

and the offset plate are installed in the correct orientation.

5) Being careful not to pinch any connectors or wires, align

and secure the Trim Switch assembly to the offset plate

using the three larger philips head screws (D) you removed

previously.

6) Reinstall the Steering Wheel. Installation is the reverse of

removal.

An optional Steering Wheel offset plate is included that lowers the position of the Steering Wheel and the Trim Switch assembly.

Some users may find the Lower Steering Wheel position more comfortable not only for hand position, but also for the overall

balance and feel of the transmitter.

To install the Steering Wheel offset plate, follow the steps below:

1) Use a 7mm nut driver to remove the Steering Wheel retaining nut, then pull the

Steering Wheel straight off and set is aside.

2) Using a philips head screwdriver, remove the three larger philips head screws (A),

then carefully pull the Trim Switch assembly off the transmitter and very carefully

unplug the two connectors.

 

 

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 115 116

Commentaires sur ces manuels

Pas de commentaire

AIRTRONICS M12 Guide de l'utilisateur Page 14

Commentaires sur ces manuels

Produits connexes et manuels pour Télécommandes AIRTRONICS M12